Measure and cut the crown molding front section measure and mark the front section of crown molding to the cabinet width.
Installing crown molding above kitchen cabinets.
Check out our video review and demo of adding crown molding to your kitchen cabinets.
Cut strips of straight 3 4 in x 1 1 2 in wood to fit the front and sides of each cabinet.
You can use 1 x 4 lumber and rip these into two or three strips.
Make sure the pieces are together and in place snugly.
Ask this old house general contractor tom silva installs crown molding on kitchen cabinets with full overlay doors subscribe to this old house.
Place the crown molding so that it is rests upside down and at a 45 degree angle against the saw fence.
Dry fit the crown molding by holding the front piece and a side piece against the front and side of the baseboard image 1.
The side of the cabinet must be flush with the side of the faceframe for the crown moulding corner to be square.
Hold the crown molding against the cabinet and tight to the ceiling then nail it to the cabinet using a pneumatic brad nailer and 1 inch brads.
Unless there is ample room above the doors to attach a crown molding or if you are using a very wide crown molding you will need to install a nailer strip to support the installation.
Use whatever scrap you have handy.
Using a nail gun nail the crown to the baseboard.
Crown molding that sits atop kitchen cabinets gives them a solid finished look.
In this video we will go over some tips and tricks that might help when.
Use one long strip for a row of cabinets the same depth then apply wood glue to each strip nail it in place and let dry.
This video teaches you how to install crown molding on cabinets with clever tricks and tips it would take you years to learn on your own.
Start by assessing the cabinets.
It is important to fill in the face frame overhang if there is one before installing crown moulding.
Cut the left hand miter joint mark the crown molding s length then use the other guide block to set the saw blade and cut the right hand miter.
Use a pin nailer to nail into the corners of the two pieces of crown molding image 2.
Set the miter saw to a 45 degree angle cut.