No need for customers to buy transport and store chlorine compounds.
Intellichlor ic40 cell light not on.
That means that the pentair ic40 life is running out limited life remaining under proper operation the intellichlor should provide at least 10 000 hrs.
Turn on the heater or lay a solar blanket over the surface of the water if the cell light is red which indicates the water temperature has fallen below 52 degrees fahrenheit.
I cleaned the cells by disconnected the ic40 unit and using cell cleaning solution purchased from my local pinch a penny and soaking the unit for about 15 minutes.
Same sanitation performance as manual chlorine addition without the drawbacks.
If i power the system down and then back up the red read more.
If this is the case the salt level on the cell will need to be recalibrated.
This ensures the intellichlor scg and pool pump will switch on and off together.
It is connected to a timer for 7 hours 10am to 5pm.
So its not producing chlorine.
Electronic chlorine generator model ic60 ic40 ic20 and ic15.
It read 60 which means 6000 hours and the chlorinator only has a life of 10 000.
This guide is only intended for versions 1 9 and below.
I had a pentair intellichlor ic40 installed last summer.
I have a pentair intellichlor ic40 installed may 14 2010.
The salt level indicator lights both the red and the green do not seem to be operating.
Caution the intellichlor ic15 power supplymust be interconnected with pool pump motor power source.
When the intellichlor scg ic15 is installed in europe.
Pentair ic40 problems and solutions.
A few days ago i observed that the lights were not working.
Intellichlor uses common table salt to produce all the chlorine a pool needs safely effectively and automatically.
Also i checked the usage by pressing the more button for 3 seconds and it tells you how many hours have been used.
The salt level is steady red low.
Occasionally the salt indicator on the pentair intellichlor will not match the actual salt level of the pool.
Intellichlor salt light shows red low salt and cell light is off.
Intellichlor recommends read more.
The following steps will provide a guide on how to recalibrate a pentair intellichlor.
Some of the most experienced problems with pentair ic40 include.
The cell light is off and will not come on even with the output at 100.
But i have added salt and used salt testing kit and it shows salt at 3740ppm.
